Filter
Top Products
CC1800XL Concrete Saw Manual 25
Transmission
Regularly wipe down the transmission (self-propelled
model) to help prevent high oil temperatures.
Adding Transmission Oil
Check the transmission oil level daily/regularly.
1. Remove the transmission oil reservoir cap.
Figure 31: Oil Reservoir Cap
2. Add Mobil ATF D/M oil or an equivalent up to the Oil
Level Cold
3. Replace the oil reservoir cap and tighten to secure.
line as necessary.
Adjusting the Drive Wheels
The drive wheels should fully engage the rear wheels
when the transmission is engaged. Check the
engagement pressure daily/regularly to avoid wheel
slippage.
Figure 32: Engagement Linkage
1. Loosen the engagement linkage nuts.
2. Move the lower engagement linkage downward so
the drive wheels fully engage the rear wheels.
3. Retighten the nuts to secure the engagement
linkage.
4. Engage the transmission to make sure the drive
wheels fully engage the rear wheels. Readjust the
engagement linkage as necessary.
Adjusting the Rear Drive Chain
Regularly inspect the rear drive chain and tighten as
necessary. Regularly lubricate the rear drive chain with
oil to increase chain life.
1. The transmission is secured to the transmission
platform with four screws and nuts. Loosen the nut
on each screw.
Figure 33: Transmission Nuts
2. Push the transmission up in the transmission
platform slots to tighten the chain. Leave a little bit of
slack in the chain and DO NOT over-tighten it.
3. Retighten all four nuts to secure the transmission to
the platform.
Belts
WARNING
• Turn off the engine/motor prior to
servicing the belts.
CAUTION
• Always let the belts cool down prior to
servicing them.
Note: Over-tensioning the belts may damage the engine
crankshaft. Under-tensioning the belts may cause
shorter belt life and/or poor saw performance. Squealing
belts indicate looseness.