Filter
Top Products
CC1800XL Concrete Saw Manual 11
Operating the CC1800XL
Handlebars
The handlebars help the operator guide and maneuver
the saw.
Adjusting the Handlebars
1. Remove the screws securing the handlebar to the
frame upright.
2. Holding the handlebar grip, move the handlebar up
or down (matching the holes on the handlebar shaft
to the holes on the frame upright) to adjust the
handlebar to the desired height. Turn the handlebar
90° to change the position if desired. Note: The
handlebar cannot be placed in the lowest position on
the hydraulic motor saw because of the location of
the hydraulic tubes
.
Figure 4: Handlebar Positions
3. Secure the handlebar to the frame upright. Adjust
the handlebar height as necessary.
4. Repeat steps 1–3 to adjust the other handlebar.
Front Pointer
The front pointer helps the operator follow the cutting
line.
Adjusting the Front Pointer
1. Remove the looped end of the shorter pointer rope
line from the handlebar grip.
2. Lower the front pointer frame to the ground.
3. Divide an 8–10 ft piece of string in half.
4. Place the looped end of string into a gullet on the
backside of the blade.
5. Place one string line up against the backside of the
blade and one string line up against the front side of
the blade. Holding the string ends in one hand,
tension the lines out toward the pointer rod.
Figure 5: String Line against Blade
6. Loosen the nuts securing the pointer rod.
7. Adjust the pointer rod to place the pointer tip in
between the tensioned string lines.
Figure 6: Pointer between Strings
8. Retighten the nuts to secure the pointer rod.
9. Lift the pointer frame off the ground when the cutting
task is complete.
10. Place the looped end of the pointer rope around the
handlebar grip.