Filter
Top Products
Before Repair
12 313289S
Pressure Relief Procedure
Relieve A and B Fluid Pressure
1. Engage trigger lock.
2. Press .
3. If fluid heaters are used, shut them off using the
controls on the heater control box.
4. Shut off feed pumps, if used.
5. Remove spray tip and clean.
6. Disengage trigger lock.
7. Hold a metal part of the gun firmly to a grounded
metal pail with a splash guard in place. Trigger gun
to relieve pressure in material hoses.
8. Engage trigger lock.
Relieve Pump Fluid Pressure
9. Close mix manifold valves (AH, AJ), then open sol-
vent flush valve (AK) on mix manifold.
10. Open solvent pump air control (CB). Use lowest
pressure needed to flush material out of hose.
Follow Pressure Relief Procedure when you stop
spraying or dispensing; and before cleaning, check-
ing, servicing, or transporting equipment.
TI1949a
Fluid Heater A
Fluid Heater B
ti21275a
TI1950a
TI1953a
TI1949a
Replace with illustration
AH
AJ
AK
312359 313289
CB
r_312359_313289_14