Graco 313289s Paint Sprayer User Manual


 
Models
313289S 7
Models
Check the identification plate (ID) for the 6-digit part number of the sprayer. Use the following matrix to define the
construction of the sprayer, based on the six digits. For example, Part XM1A00 represents an XM Plural-Component
sprayer (XM); 5200 psi pump set with pump filters (1); wall power supply, no heaters, no junction box, and is not
approved for hazardous areas (A); with no additional kits (00).
NOTE:
Some configurations in the following matrix cannot be built. Consult with distributor or Graco representative.
To order replacement parts, see Parts section in this manual. The digits in the matrix do not correspond to the Ref.
Nos. in the Parts drawings and lists.
Location Category Key:
NE Not for use in European explosive atmosphere locations or hazardous locations.
EH For use in explosive atmospheres and hazardous locations
.
XM sprayers are not approved for use in hazardous
locations unless the base model, all accessories, all
kits, and all wiring meet local, state, and national
codes.
XM 1 A
00
First and
Second
Digits
Third Digit Fourth Digit
Fifth and
Sixth
Digits
System Choice
(See Table 1 for lower models) Kit Choice
Additional
Kit
Pump Set
(hose/gun)
Pump
Filters
Remote
Manifold
Control
Box
Fluid
Heaters
Junction
Box
Location
Category
Approvals
(See page 8
for approvals)
See Table
2 for
selections
XM
(plural com-
ponent
sprayer
mounted
on a frame)
1 5200 psi
A
Wall Power
Supply NE
CE, FM,
FM
c
2 5200 psi B
Wall Power
Supply
✔✔
NE CE, FM,
FM
c
3 6300 psi
C
Wall Power
Supply
NE CE, FM,
FM
c
4 6300 psi D
IS/
Alternator EH
CE, FM,
FM
c,
Ex
5 5200 psi
✔✔
E
IS/
Alternator
EH
CE, FM,
FM
c,
Ex
6 5200 psi
7 6300 psi
✔✔
8 6300 psi