Filter
Top Products
-64-
Model G0602/G0752 (Mfg. Since 11/12)
Figure 97. Model G0602 low-range belt.
Model G0752:
Loosen the tensioner lock bolt, then pivot the
tensioner to the left and secure it temporarily.
Remove the V-belt (see Figure 98) and re-install
the new one. Follow Steps 4-5 on Page 63 to ten-
sion the belt.
Figure 98. Model G0752 V-Belt.
V-Belt
Tensioner
C
B
To tension the Model G0602 high range
V-belt:
1. Follow Steps 1–3 in "Tensioning Timing Belt"
on Page 65.
2. Lower the motor and re-tighten the mounting
hex nuts. The high range V-belt is correctly
tensioned when there is approximately
1
⁄4"
deflection when it is pushed with moderate
pressure, as shown in Figure 95 on Page 63.
—If there is more than
1
⁄4" deflection when
the V-belt is pushed with moderate pres-
sure, loosen the motor mount nuts, lower
the motor as needed, then tighten the nuts.
3. Check the timing belt tension (refer to Step 5
of "Tensioning Timing Belt" on Page 65).
4. Secure the change gear cover.
Replacing V-Belt
1. DISCONNECT LATHE FROM POWER!
2. Open the change gear cover.
3. Model G0602:
—If the high range belt (Figure 96) needs to
be replaced, loosen the motor mount hex
nuts, (see Figure 99 on Page 65), raise
the motor, and carefully roll the belt off of
pulleys A and C. Install a new V-belt, then
follow the steps in "To tension the Model
G0602 high range V-belt" above.
Figure 96. Model G0602 high-range belt.
A
C
High
Range Belt
—If the low range belt between pulleys B and
C (see Figure 97) needs to be replaced,
loosen the tensioner lock nut (see Figure
93 on Page 63), move the tensioner down,
roll the belt off the pulleys, then re-install
the new V-belt. Follow Steps 4-5 on Page
63 to tension the belt.
Lock Bolt
Tensioner