Filter
Top Products
-30-
Model G0768/G0769 (Mfd. Since 8/15)
The following adjustments have been made at the
factory. However, because of the many variables
involved with shipping, we recommend you verify
these adjustments to ensure the best results:
Factory adjustments that should be verified:
• Tailstock alignment ........................ Page 39
• Cross slide backlash adjustment .....Page 82
• Leadscrew backlash ........................Page 82
• Gib adjustments ............................. Page 83
Recommended
Adjustments
14. Rotate spindle speed dial all the way coun-
terclockwise, then press Emergency Stop
button.
15. Repeat Steps 7–10 from Lathe Spindle
Break-In in a similar manner for mill.
Congratulations! Mill spindle break-in is complete.