Filter
Top Products
Model G0768/G0769 (Mfd. Since 8/15)
-63-
Table Travel
The cross slide table travels in two directions, as
illustrated in Figure 105:
• X-axis (longitudinal)
• Y-axis (cross)
X-Axis or Longitudinal Travel (Left & Right)
Y-Axis or
Cross Travel
(In & Out)
Figure 105. Possible directions of cross slide
travel.
Cross Slide Handwheel (Y-Axis)
Graduated Dial
Increments .................................0.002" (0.05mm)
One Full Revolution .....................0.08" (2.03mm)
Use this handwheel to move the cross slide table
toward or away from the tooling. The cross slide
handwheel has a direct-read graduated dial,
which will read twice the actual table cross feed
travel.
Carriage Handwheel (X-Axis)
Graduated Dial
Increments ................................... 0.01" (0.25mm)
One Full Revolution .......................... 1" (25.4mm)
Use the carriage handwheel to move the carriage
left or right along the bed. Adjust the position of
the graduated scale by holding the handwheel
with one hand and turning the dial with the other.
Figure 106. Table travel controls.
These movements are controlled by the carriage
handwheel and cross slide handwheel, (see
Figure 106).
Cross Slide
Handwheel
(Y-Axis)
Cross Slide
Table
Carriage
Handwheel
(X-Axis)