Filter
Top Products
7 Send the new waveform to the function generator. Click the I/O menu
option and then Send Waveform... from the drop-down menu or click
the Send Waveform icon. The Send Waveform dialog box appears.
Change the AMPLITUDE value to 1.0 and click OK. The waveform is sent
to the function generator. The function generator will output the new
waveform once all the data points have been received.
If the I/O | Send Waveform ... menu is not active (gray),
HP BenchLink/Arb did not find a function generator on the specified
interface. Check that the function generator is properly connected to the
computer and turned on. Refer to the section "Configuring the Interface"
in Chapter 3 for more information.
2
Chapter 2 Quick Start
To Create, Save, and Output an Arbitrary Waveform
21