Filter
Top Products
31
Installing a standard form-factor expansion card
If a SCSI drive is connected to SCSI connector 0 (J94), you must remove it before you can install a
standard form-factor expansion card. You cannot have both a drive that is connected to SCSI
connector 0 and a standard form-factor expansion card installed into the blade server.
If the drive that is connected to SCSI connector 0 contains any information you want to keep, back
up the information. If the SCSI drive that is installed in SCSI connector 0 is part of a RAID array,
delete the SCSI RAID array. When you delete the array, the array configuration information is
removed. No data is deleted. After backing up the data and removing the RAID array, see
“Removing a SCSI hard disk drive” on page 23 to remove the drive.
Complete the following steps to install a standard form-factor I/O expansion card:
1. Read the safety information beginning on page “Safety” on page vii and “Installation
guidelines” on page 19.
2. Shut down the operating system, turn off the blade server, and remove the blade server from the
SBCE unit (see “Installing and removing the blade server from the SBCE unit” on page 20 for
information).
3. Carefully lay the blade server on a flat, non-conductive surface.
4. Open the cover (see “Opening the blade server cover” on page 20 for instructions).
5. If an SCSI drive is in SCSI connector 2, remove the drive and tray (see “Removing a SCSI hard
disk drive” on page 23 for instructions) (save the screws that secured the tray to the system
board); otherwise, remove the existing rear-board mounting screws (near SCSI connector 2).
6. Install the standard form-factor I/O expansion card:
Figure 11. Installing a standard form-factor expansion card in the blade server .
PRESS HERE W
HEN
INSTALLING CARD
Expansion card
Expansion
card tray
Hard disk
drive tray