Intel SBX82 Saw User Manual


 
54 Intel Server Compute Blade SBX82 Installation and User’s Guide
The service processor in your blade server provides the following features:
Continuous health monitoring and control
Configurable notification and alerts
Event logs that are timestamped, saved in nonvolatile memory, and can be attached to e-mail
alerts
Remote graphics console redirection
Point-to-point protocol (PPP) support
Remote power control
Remote firmware update and access to critical server settings
Around-the-clock access to the blade server, even if the server is turned off
At some time, you might have to flash the service processor to apply the latest firmware. Download
the latest firmware for your blade server service processor from the Intel Support Web site. Use the
management-module Web interface to flash the service processor. The Web interface is described in
the Intel
®
Server Management Module SBCECMM: Installation and User’s Guide.
Configuring the Gigabit Ethernet controllers
Two Ethernet controllers are integrated on the blade server system board. Each controller provides a
1000-Mbps full-duplex interface for connecting to one of the Ethernet-compatible switch modules in
I/O module bays 1 and 2, which enables simultaneous transmission and reception of data on the
Ethernet local area network (LAN). Each Ethernet controller on the system board is routed to a
different switch module in I/O module bay 1 or bay 2. The routing from Ethernet controller to I/O
module bay will vary based on blade server type and the operating system that is installed. See
“Blade server Ethernet controller enumeration” on page 55 for information about how to determine
the routing from Ethernet controller to I/O module bay for your blade server.
You do not have to set any jumpers or configure the controllers for the blade server operating system.
However, you must install a device driver to enable the blade server operating system to address the
Ethernet controllers. For device drivers and information about configuring your Ethernet controllers,
see the Broadcom NetXtreme Gigabit Ethernet Software CD that comes with your blade server.
Your Ethernet controllers support failover, which provides automatic redundancy for your Ethernet
controllers. Without failover, you can have only one Ethernet controller from each server attached to
each virtual LAN or subnet. With failover, you can configure more than one Ethernet controller from
each server to attach to the same virtual LAN or subnet. Either one of the integrated Ethernet
controllers can be configured as the primary Ethernet controller. If you have configured the
controllers for failover and the primary link fails, the secondary controller takes over. When the
primary link is restored, the Ethernet traffic switches back to the primary Ethernet controller. (See
your operating system device driver documentation for information about configuring for failover.)
Important: To support failover on the blade server Ethernet controllers, the Ethernet switch
modules in the SBCE unit must have identical configurations to each other.