Filter
Top Products
LAN Screen
Use the LAN link on the main menu to reach the LAN screen. An example screen is
shown below.
Figure 10: LAN Screen
Data - LAN Screen
TCP/IP
IP address for the WBR-3600 Router, as seen from the local
LAN. Use the default value unless the address is already in use
or your LAN is using a different IP address range. In the latter
case, enter an unused IP Address from within the range used by
your LAN.
IP Address
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the WBR-3600 Router is attached (the same
value as the PCs on that LAN segment).
Subnet Mask
DHCP Server
• If Enabled, the WBR-3600 Router will allocate IP Addresses
to PCs (DHCP clients) on your LAN when they start up. The
default (and recommended) value is Enabled.
• If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-
configured to treat the WBR-3600 Router as the default
Gateway. See the following section for further details.
• The Start IP Address and Finish IP Address fields set the
values used by the DHCP server when allocating IP
Addresses to DHCP clients. This range also determines the
number of DHCP clients supported. Enter the desired value
for the Lease Time, which should be between 1 and 7.
See the following section for further details on using DHCP.
19