Filter
Top Products
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the WBR-3600 Router's
Access Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the WBR-3600 Router, each Wireless Station
must have compatible settings, as follows:
Mode The mode must be set to Infrastructure (rather than Ad-hoc)
Access points only operate in Infrastructure mode.
This must match the value used on the WBR-3600 Router. The
default value is Wireless.
Note! The SSID is case sensitive.
SSID (ESSID)
By default, Wireless security on the WBR-3600 Router is
disabled.
• If Wireless security remains disabled on the WBR-3600
Router, all stations must have wireless security disabled.
• If Wireless security is enabled on the Wireless Router (either
WEP or WPA-PSK), each station must use the same settings
as the Wireless ADLS Router.
Wireless
Security
Wireless Configuration on Windows XP
If using Windows XP to configure the Wireless interface on your PC, the configuration
procedure is as follows:
1. Open the Network Connections folder. (Start - Settings - Network Connections).
Figure 26: Network Connections (Windows XP)
2. Right-click the Wireless Network Connection, check that it is enabled (menu
option says Disable, rather than Enable) and then select View Available Wireless
Networks.
3. You will then see a list of wireless networks.
42