Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
B-2
OPERATION
B-2
CONTROLS AND THEIR
FUNCTIONS
CONSTANT CURRENT CONTROLS
Operator controls for welding using a constant current
power source are illustrated in Figure B.1. Refer to the
figure and the following explanations of the controls.
FIGURE B.1 – CONSTANT CURRENT CONTROLS
LN-8
Read and understand this entire section before
operating your machine.
SAFETY INSTRUCTIONS
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts such
as output terminals or internal wiring.
• Insulate yourself from the work and ground.
• Always wear dry insulating gloves.
____________________________________
FUMES AND GASES
can be dangerous.
• Keep your head out of fumes.
• Use ventilation or exhaust to remove
fumes from breathing zone.
____________________________________
WELDING, CUTTING and
GOUGING SPARKS
can cause fire or explosion
• Keep flammable material away.
• Do not weld, cut or gouge on containers
that have held combustibles.
____________________________________
ARC RAYS
can burn.
• Wear eye, ear and body protection.
____________________________________
Only qualified personnel should operate this equip-
ment. Observe all safety information throughout this
manual.
WARNING
CURRENT
CONTROL
VOLTAGE
CONTROL
CIRCUIT
BREAKER
TRIGGER
INTERLOCK
GROUND LEAD
PROTECTOR
RESET BUTTON
WIRE FEED
DIRECTION
CONTROL