Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
F-11
TROUBLESHOOTING AND REPAIR
F-11
FIGURE F.1 – LN-8 ELECTRICAL SEQUENCE OF OPERATION (continued)
LN-8
DE-ENERGIZES
2 CR
REED SWITCH
OPENS INTERLOCK
ON 1 CR (NOTE 2)
OPENS 531-7
DE-ENERGIZES 1 CR
OPENS 683-32A CIRCUIT
CLOSES 682-683
REVERSES
MOTOR FIELD
WELDING
ELECTRODE IS
COLD TO WORK
RELEASE
GUN TRIGGER
OPENS 2-8 (NOTE 1)
OPENS 2-4 CIRCUIT
DE-ENERGIZES
POWER SOURCE
CONTACTOR
BREAK
WELDING ARC
DE-ENERGIZES
POWER SOURCE
PILOT RELAY
DISCONNECTS MOTOR ARMATURE
AND CONTROL CIRCUIT FROM
INPUT AC LINE - (DE-ENERGIZES
AUX. EQUIPMENT IF CONNECTED)
3CR (NOTE 3)
REED SWITCH
MOMENTARILY
CLOSES
DYNAMIC BRAKE
CURRENT FLOWS
THROUGH FREE
WHEELING DIODE (D-7 ON
CONTROL BOARD)
DISCHARGES SLOW
ACCELERATION
CAPACITOR (C3 ON
CONTROL BOARD)
MOTOR STOPS
RESETS SLOW
ACCELERATION
CIRCUIT
UNIT READY
FOR NEXT WELD
NOTE 1: When interlock is open.
NOTE 2: When interlock is closed.
NOTE 3:
3 CR is not used on units with code no. 7926 and up.