Filter
Top Products
Toolbars
46
Copyright 2006 Pico Technology Limited. All rights reserved. PSW044-2.0
7.2.1
Open Device dialog
When PicoScope is not sure which scope device to use, it displays a list of all the
units attached to your computer and allows you to select which one to use.
Where to find it
PicoScope always tries to locate the correct scope device to use without asking you.
This dialog appears only there is no suitable scope, or when there is more than one
scope and you have not yet specified which one to use.
See "How to change to a different scope device " if you wish to switch to a different
scope device later.
You will also see this dialog if you click the New Capture Window button when no
scope device is connected.
Procedure
To restrict the selection to a particular series of devices, click on the device drop-
down box and select a device series; otherwise, click the Find All
button.
Wait for a list of devices to appear in the grid.
Select one device and click the OK
button.
PicoScope will open a new capture window and scope view for the selected
scope device.
Use the toolbars to set up the scope device and the scope view to display
your signals.
Demo mode
To experiment with PicoScope with no scope device connected, choose one of the
Demo devices from the drop-down list. The Demo Signals dialog will then appear,
allowing you to set up one or more test signals.
68
61
45
9 14
44 68 14
68
59