Filter
Top Products
OfficeServ 7100 Installation Manual
© SAMSUNG Electronics Co., Ltd. 3-3
3.2 Mounting Control Boards
This section describes how to set the switches of MP10/11 control board, mount the option
boards, insert to the slots and connect MP10/11 board.
3.2.1 Setting Switches and Mounting Option Boards.
MP10/11 has the switches to set the board operation for the user’s purpose and fitting with
the system configuration. The way to set the switches and mount the boards are as follows:
1) Set S1 switch of the MP10/11 board as On and Pin 1 to Pin 4 of S2 switch as Off.
Pin 6 to Pin 8 are set depending on the user’s purpose.
Figure 3.2 Setting Switches of MP10/11 Board
Table 3.3 Switches of MP10/11 Board
Switch Description
S1 Set S1 as On before mounting on the slot for memory backup.
If switched On when the switch is Off. all data in the database are automatically
initialized. To store the data in the database, operate the system after turning on the
S1 switch.
SW1~SW4 the pins are set the country code that the system will be used. S2
SW6~SW8 Sets the number of digits for C.O./extension lines and extension.
[ Not-used : Always default 3 digits ]
SW6-On: 4 digits for C.O. line
Off: 3 digits for C.O. line
SW7-On: 4 digits for an extension group
Off: 3 digits for an extension group
SW8-On: 4 digits for an extension number
Off: 3 digits for an extension number
S1
On
Off
S2
Off
On