Filter
Top Products
CHAPTER 3. Ошибка! Стиль не определен.
3-14
© SAMSUNG Electronics Co., Ltd.
3.5 Replacing Boards
If the OfficeServ 7100 system fails to operate normally due to an error on the power supply
board, control board, or interface board, replace the board to a new one.
Removing Cables
Replace a board after removing all cables connected to the board.
The procedure for replacing a board mounted in a slot of a cabinet is as follows:
1) Turn off the power of the cabinet equipped with the board to be removed.
Figure 3.14 Turning the Cabinet Power Off
2) Extract the board by pulling the lever of the board carefully.
Figure 3.15 Removing a Board