Filter
Top Products
Assembly
5. Position rear support, with slide brack-
ets attached, inside right side panel, so
short tabs point up, and solid surface
faces front.
6. Attach rear support to side panel: use
two screws (insert screws through side
panel); on end of each screw put washer,
then nut, and wrench tighten.
7. Attach slide brackets to front inside
edge of side panel: use three screws (in-
sert screws through slide brackets); on end
of each screw put washer, then nut, and
wrench tighten.
8. Repeat steps 4-7, installing slide brack-
ets to right side of another rear support
and attaching rear support, with slide
brackets attached, to left side panel.
Short
Tabs _ -_
9. Attach four slide brackets to remaining
rear support, one on each side of center
hole and one on each side of second hole
from top: use four screws (insert screws"
through larger hole in slide bracket); on
end of each screw put washer, then nut,
and wrench tighten. Set this"rear support
cL_idefor later use. Remaining two slide
brackets will be installed later.
10. Go to "Attach Side Panels to Bottom
Shelf."
Assemble Side Panels(Only Door
Model without Casters)
1. Set out:
-right side panel
-left side panel
-two spacers
-four leveling feet
-four vq" diam x 1/2"long truss head
SCreWS
-four v4"diam lock washers
-four 1/a"diam hex nuts
-eight _ia"diam hex nuts.
J
Larger
Hole
19