Filter
Top Products
Alignment and Adjustment
2. Place square so long edge rests on
table and short edge rests against blade
surface, not on a tooth.
3. There should be no gap between blade
and square. Note: Not all blades are per-
fectly flat. Check different points along
blade surface by making quarter turns and
looking for gap each time. Consider overall
fit of blade. If there is no gap, no adjust-
ment is needed.
Correct
Wrong
I
t
wrong
4. If there is a gap, adjust motor:
i) unlock bevel lock
ii) loosen four socket head screws behind
blade carriage
iii) move motor until blade rests flush
against square
iv) lock bevel lock.
5. Re-check alignment and adjust as
needed.
6. Tighten four socket head screws be-
hind blade carriage. @
41