Filter
Top Products
Assembly
Attach Slide Arm Supports
1. Set out:
-two slide arm supports
-four v4"diam x _" long pan head type
AB screws
-front table.
2. Identify top and bottom of table: top
has countersunk holes. Place table bot-
tom side up.
3. Attach slide arm supports, solid sides
down, to table: use two screws per sup-
port; tighten, but not fully, because sup-
port will have to be adjusted later.
Install Front Table
1. Set out:
-three tee nuts
-five rubber bushings
-five 1/4"U-clips
-five 1/4"diam x 1_'4"long mounting screws
-two v4"diam x 1/2"long truss head screws
-three 1/4"diam x 7/8"long cup point set
screws
-five _7/_"in. diam x _/8"out. diam flat
washers
-two 17/64"in. diam x 9/16out. diam fiat
washers
-two v4" diam lock washers
-two 1/4"diam hex nuts.
2.With front table still bottom side up,
hammer tee nut into each leveling hole.
Tee
Nut
Leveling Holes
3O