Filter
Top Products
4. Attach slide arms to slide arm sup-
ports: use one 1W' long screw per slide
arm; put fiat washer on screw; insert
screw through slide arm; on other end of
screw put another flat washer; put screw
through slide arm support; on end of
screw put lock washer, then hex nut and
wrench tighten.
5. Attach slide arms to lock handle chan-
nels: use one _" long screw per slide arm;
insert screw through slide arm; on end of
screw put flat washer; put screw through
lock handle channel; on end of screw put
square lock nut and tighten.
Install Drawers (Only Drawer Model)
1. Slide each drawer into place and push
all the way in.
2. Pull each drawer out as far it will go.
They should not come all the way out. If
any do, use screwdriver to bend out stop
tabs on slide brackets and re-test drawer.
To Remove Drawers (Only Drawer
Model)
1. Llse screwdriver to push in one stop
tab on right slide bracket and at same
time pull drawer out slightly.
2. Repeat with left slide bracket and pull
drawer all way out.
Alignment and Adjustment
Go to Alignment and Adjustment Section
and follow all instructions. You cannot
use the saw until it is aligned and ad-
justed. It may be helpful to read the Con-
trols Section before proceeding with
alignment and adjustment.
Reinaining parts will be installed in Digi-
tal Display Section.
Assembly
!
33