Filter
Top Products
Assembly
2. Position rear support so short tabs are
at top. Attach four slide brackets to cen-
ter support (make sure solid surface of
support faces out): use four screws (insert
screws through slide brackets'); on end of
each screw put washer, then nut, and
wrench tighten.
3. With solid surface on top, put upper
support between rear and center sup-
ports, so it sits inside tabs of rear support
and inside center support.
4. Attach two slide brackets at top: posi-
tion them so larger holes line up on rear
support; use two screws per bracket (in-
sert screws through slide bracket); on end
of each screw put washer, then nut, and
wrench tighten.
5. Tilt center slide assembly and slide in-
side cabinet, under front and rear skirts,
so center support rests on lower support.
6. Attach center slide assembly to front
and rear skirts: use tw'o screws per skirt
(insert screws through upper support); on
end of each screw put washer, then nut,
and finger tighten.
7. Attach center and rear supports to
lower support: use four screws (insert
screws through front and rear supports); on
end of each screw put washer, then nut,
and wrench tighten.
Front
Skirt
Center
Support
I
/
g
Lower Support
25