Sears 113.197411 Saw User Manual


 
Crosscuttin
Repetitive Crosscutting
Repetitive crosscutting is the repeated
and continuous cutting of many pieces of
lumber to the same length. Carriage and
length stops can help make this type of
crosscutting more efficient. A lower blade
guard offers protection against the side of
the blade (See Accessories).
A carriage stop defines the distance
needed to pull the blade through to com-
plete each cut. This will prevent pulling
the blade through more than the recom-
mended distance.
To make a carriage stop use lx2 lumber:
i) cut two pieces, each 2" long
ii) clmnp a piece on each side of radial
arm, so blade carriage stops at distance
needed to complete cut
iii) check that clamps do not interfere
with hand grip on saw handle.
A length stop defines the cut length and
ensures that all pieces will be cut to the
same size. Clamp a piece of lx2 lumber
on the fence to define the cut length. Use
a length stop only on the end of tile
workpiece which is held down.
Crosscutting Hints
1. To extend life of table top, buy
auxiliary table cover (see Accessories) or
make one out of */4"plywood or fiber-
board. Clamp or nail to original table top,
section by section. If you use nails, nail in
the four corners to make sure blade will
not contact nails.
2. Make several fences, so each will have
only a few kerfs (See Cutting Aides). Too
many kerfs in a fence weaken it.
3. When making miter or bevel cuts, use
extra force to hold workpiece down be-
Carriage Stop
Length Stop
cause it tends to move during these types
of cuts.
4. When cutting hard woods, like oak, or
making compound cuts, keep arm hold-
ing saw handle rigid and pull blade
through slowly.
5. Keep table clean of chips and sawdust.
6. Use the right blade for each job.
7. Use sharp blades.
8. To keep cut line accurate, periodically
check blade alignment.
9. Do not cut severly warped or crooked
workpieces.
6O