Filter
Top Products
Assembly
10. Push bevel lock to left (locking direc-
tion) as far as it will go. Space between
casting and bevel lock should be about
1/16" :
to increase space, unlock bevel lock then
tighten lock nut on motor support;
to decrease space, unlock bevel lock then
loosen lock nut on motor support.
1/16"-_
Bevel
_'_ Lock Lock
11. Lock bevel lock. With tabs on outside,
insert one end of yoke plug into opening
in blade carriage, just behind bevel lock.
Push until plug snaps into place.
Mount Basic Saw Assembly
1. Set out:
-basic saw assembly
-eight v4"diam x v2"truss head screws
-eight v4"diam lock washers
-eight v4"diam hex nuts.
2. Lift saw assembly by front edge and
column and place on cabinet so holes line
up.
3. Attach saw to cabinet: use eight screw's
(insert screws through saw frame); on end
of each screw put washer, then nut and
wrench tighten.
4. Check and wrench tighten all nuts in
cabinet.
5. Put saw in location where it will be
used.
.L !
I
|
k,
I
Cabinet
28