Filter
Top Products
Alignment and Adjustment
1. Lock blade in in-rip position (blade
towards column, motor towards table
front).
2. Lower blade until it just clears table.
3. Unlock rip lock, move blade back until
it touches fence, and lock rip lock.
4. Loosen pawls/spreader wing nut and
lower pawls/spreader to fence. Spreader
should rest flat against fence, and one set
of pawls should rest on top of fence.
5. If adjustment is needed:
i) loosen both spreader nuts
ii) slide spreader against fence and rest
pawls on fence
iii) tighten spreader nuts.
6. Raise pawls/spreader unit up to guard
and tighten wing nut.
Complete Adjustments
Go to Digital Display Section and follow
instructions to irkstall battery, align en-
coders, and set zero reference points.
Pawl
Fence
Wren(
F
Correct
Table
Spreader
Saw
Blade
Wrong
47