Filter
Top Products
-4-
For Machines Mfg. Since 3/11
16-Speed Gearhead Lathe
INTRODUCTION
General Identification
K. Tailstock
L. Longitudinal Leadscrew
M. Feed Rod
N. Coolant Tank & Pump Access
O. Carriage
P. Brake Pedal
Q. Chip Drawer
R. Micrometer Stop
S. Spindle Motor 2-Speed Switch
T. Quick-Change Gearbox Controls
U. Headstock Controls
A. Headstock
B. D1-6 Camlock MT#6 Spindle
C. Chuck Guard w/Safety Switch
D. Steady Rest
E. Follow Rest
F. Halogen Work Lamp
G. 4-Way Tool Post
H. Fagor 2-Axis DRO (SB1054F & SB1055F
only)
I. Compound Rest
J. Coolant Nozzle & Valve
Serious personal injury could occur if
you connect the machine to power before
completing the setup process. DO NOT
connect power until instructed to do so later
in this manual.
Untrained users have an increased risk
of seriously injuring themselves with this
machine. Do not operate this machine until
you have understood this entire manual and
received proper training.
Figure 1. General identification (Model SB1054F shown).
D
E
C
B
F
G
I
J
K
N
O
Q
P
S
T
U
L
M
R
H
A