Filter
Top Products
Getting Started
2
PS2520G and PS2521G Programmer Manual
GPIB Device
GPIB Device
GPIB Device
GPIB Device
GPIB Device
GPIB Device
GPIB Device
Figure 1: Typical GPIB Network Configuration
Connecting a Controller
You must have a GPIB controller, such as a PC with a GPIB card, to
operate the programmable power supplies over the GPIB interface.
Figure 2 on page 3 shows the location of the GPIB port on the rear
panel.
Connect the programmable power supply to a GPIB controller as
follows:
1. Connect one end of a GPIB cable to the GPIB controller.
2. Connect the other end of the GPIB cable to the GPIB port on the
programmable power supply.
3. Turn on the programmable power supply.
4. Turn on the GPIB controller.