Filter
Top Products
Getting Started
PS2520G and PS2521G Programmer Manual
3
GPIB port
Figure 2: GPIB Port
Setting the Address
Change the GPIB address of the programmable power supply using
the following procedure:
NOTE. Each device connected to the same controller must have a
unique GPIB address. The factory default address for the PS2520G
and PS2521G Programmable Power Supplies is 12.
1. Make sure the AUTO SEQ function is off. (The indicator for
AUTO must be off).
2. Press LOCAL → (number) → (return
) to enter the GPIB
address of the power supply. (The address must be a number
between 0 and 30.)