Tektronix THS720P Work Light User Manual


 
Maintenance
THS710A, THS720A, THS730A & THS720P Service Manual
6–5
Removal and Installation Procedures
This section describes how to remove and install the major mechanical and
electrical modules. It provides the following information:
H List of Modules on page 6–5 describes where to locate a list of replaceable
modules.
H Summary of Procedures on page 6–6 lists the procedures for removal and
installation of modules.
H Tools Required on page 6–7 describes the tools needed to perform the
procedures.
H Tilt Stand, on page 6–8, begins a series of procedures that describe the
removal and installation of modules.
Please read the following warning statement. Then read the following general
instructions before removing a module.
WARNING. Only qualified personnel should perform service procedures. Before
doing this or any other procedure in this manual, read the General Safety
Summary and Service Safety Summary found at the beginning of this manual.
Also, to prevent possible injury to service personnel or damage to electrical
components, read Preventing ESD on page 6–1.
1. Read the Summary of Procedures on page 6–6 to understand which
procedure to use to access a given module. Then read Tools Required on
page 6–7 for a list of tools needed to remove and install modules in the
TekScope instrument.
2. If you are disassembling the TekScope instrument for cleaning, refer to the
Inspection and Cleaning procedure on page 6–2 for cleaning instructions.
The Mechanical Parts List chapter provides a list of all replaceable modules.
Any electrical or mechanical module, assembly, or part listed in the parts list is
referred to as a module.
Preparation
List of Modules