Filter
Top Products
Maintenance
6–10
THS710A, THS720A, THS730A & THS720P Service Manual
You will need a sharp knife and needle-nose pliers to remove a defective
front-panel label.
CAUTION. Removal of a front-panel label will destroy it. Do not remove it unless
it is defective and needs to be replaced.
Removal. Use this procedure to remove a defective front-panel label.
1. Use the sharp knife to pry up a corner of the label.
2. Use the needle-nose pliers to peel the label off.
Installation. Use this procedure to install a new front-panel label in either a new
or the existing front cover.
1. Peel the paper off the back side of the new label.
2. Handling the label by its edges only, align it with the recess in the front
cover as shown in Figure 6–3.
3. When properly aligned, press the new label into place.
Front-panel label
Recess in the front cover
Figure 6–3: Installing a new front-panel label
Front-Panel Label