Super Finish 27 • 31
26
GB
Safety regulations
All local regulations in force must be observed.
For secure handling of Airless high-pressure spraying
units the following safety regulations are to be observed:
Flash point
Danger
at which vapours develop from the coating
material.
-
Danger
Do not use the unit in work places which are
-
tions.
Danger
-
Danger of injury through the spray jet
Danger
animals.
the body.
-
sures arising can cause very dangerous injuries.
be injected into the skin. Do not treat a spray injury as
a harmless cut. In the case of injury to the skin through
and correct treatment. Inform the doctor about the coat-
ing material or solvent used.
Secure spray gun against unintended
operation
Always secure the spray gun when mounting or dis-
mounting the tip and in case of interruption to work.
Danger
In case of high operating pressure, pulling the trig-
ger guard can eect a recoil force of up to 15 N.
If you are not prepared for this, your hand can be
thrust backwards or your balance lost. This can
lead to injury.
vapours of solvents
Wear respiratory protection when spraying.
The user must be provided with a breathing mask.
Protective clothing, gloves and possibly skin protection cream
are necessary for the protection of the skin.
Observe the regulations of the manufacturer concerning coat-
ing materials, solvents and cleaning agents in preparation,
processing and cleaning units.
gun accessories and high-pressure hose may not fall short
stated on the unit.
High-pressure hose (safety note)
Electrostatic charging of spray guns and the high-pressure
hose is discharged through the high-pressure hose.
For this reason the electric resistance between the connec-
tions of the high-pressure hose must be equal or
lower than 1 M.
i
hoses.
Danger
Under certain circumstances, electrostatic charg-
ing can occur on the unit due to the rate of ow of
the coating material when spraying. On discharg-
ing this can result in the emergence of sparks or
re. It is therefore necessary that the unit is always
earthed through the electrical installation. The connection
must take place through a correctly earthed two-pole-and-
earth socket outlet.
any connected cable drum completely.