Super Finish 27 • 31
30
GB
Description of unit / Starting operation
Super Finish
27
Super Finish
Voltage: 230 Volt~,50 Hz
Fuse protection: 16 A slow-blow
Voltage on multifunction
switch: 24 V
Unit connection line: 6 m long, 3 x 1.5 mm²
Socket on unit: 230 Volt ~,50 Hz
Max. connection: 1000 Watt
Type of protection: IP 44 IP 54
Capacity: 1.5 kW 1.7 kW
Max. operating pressure: 250 bar (25 MPa)
Max. volume ow: 3.0 l/min
3.5 l/min
(220 Volt~,
60 Hz)
3.5 l/min
Volume ow at 120 bar
(12 MPa) with water:
2.5 l/min
3.1 l/min
(220 Volt~,
60 Hz)
3.2 l/min
Max. size of tip: 0.027 inch
– 0.69 mm
0.031 inch
– 0.79 mm
Max. temperature of the
coating material: 43°C
Max. viscosity: 25.000 mPa·s
Net weight: 40 kg 43 kg
Hydraulic lling quanitity: 0.9 Litre, ESSO NUTO H 22
Max. tyre pressure: 2 bar (0.2 MPa)
Max. acoustic pressure
level:
74 dB (A)*
*Place of measuring: 1 m in distance from the unit and 1.6 m
above the oor, 120 bar (12 MPa) operating pressure, reverber-
ant oor
Push or pull unit.
Loosen terminal sleeves (g. 5, item 1) on the shaft ( open).
Extract shaft to the desired length.
Tighten terminal sleeves again by hand ( closed).
3
5
4
1
Unroll high-pressure hose and lay it over the shaft. Secure the
unit by means of suitable fastening.
4.
Screw o dust protection cap (g. 6, item 1).1.
Pay attention to clean sealing areas on the connections.
2.
Pay attention to the fact that the red inlet (2) is inserted into
the coating material inlet.
Screw and tighten the union nut (3) on the suction pipe (4) 3.
onto the coating material inlet (5) with the accompanying
spanner 41 mm.
Screw the union nut (6) on the return pipe (7) onto the
4.
connection (8).
3
5
4
6
3
4
5
7
1
8
2
4.2
Screw o dust protection cap (g. 7, item 1).1.
Pay attention to clean sealing areas on the connections.
2.