Filter
Top Products
Prestige 100 and 100IH ISDN Router and Router/Hub
8-14 Filter Configuration
8.4.2 Remote Node Filters
Go to Menu 11.5 (shown below) and enter the number(s) of the filter set(s) as appropriate. You
can cascade up to four filter sets by entering their numbers separated by commas. The factory
default filter set, NetBIOS_WAN, is inserted in protocol filters field under Call Filter Sets in
Menu 11.5 to block local NetBIOS traffic from triggering calls to the remote node.
Figure 8-8 Filtering Remote Node traffic
8.4.3 Default Dial-in Filter
Use Menu 13.1 – Default Dial-in Filter to specify the filter set(s) to apply to the incoming and
outgoing traffic between all dial-in users and your Prestige. Note that these filter set(s) only apply
to the dial-in users but not the remote nodes. You can specify up to 4 filter sets separated by
comma, e.g., 1, 5, 9, 12, in each filter field. The default is no filters.
Figure 8-9 Default Dial-in Filter
Menu 13.1 - Default Dial-in Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters= 1
device filters=
Factory
Default
Filter