Filter
Top Products
Prestige 100 and 100IH ISDN Router and Router/Hub
2-20 Hardware Installation and Setup
When you are finished, press ENTER at the message: ‘Press ENTER to confirm’, the Prestige
uses the information that you entered to initialize the ISDN line. It should be noted that whenever
the switch type is changed, the ISDN initialization takes slightly longer.
At this point, the Prestige asks if you wish to test your ISDN. If you select Yes, the Prestige will
perform a loop-back test to check the ISDN line. If the loop-back test fails, please note the error
message that you receive and take the appropriate troubleshooting action.
Figure 2-15 Loopback test
2.9 Ethernet Setup
This section describes how to configure the Ethernet using Menu 3 – Ethernet Setup. From the
Main Menu, enter 3 to open Menu 3.
Figure 2-16 Menu 3 - Ethernet Setup
Menu 3 - Ethernet Setup
1. General Setup
2. TCP/IP and DHCP Setup
Enter Menu Selection Number:
Setup LoopBack Test...
Dialing to 40000// ...
Sending and Receiving Data ...
Disconnecting...