Filter
Top Products
Prestige 100 and 100IH ISDN Router and Router/Hub
10-12 System Maintenance
The following table describes the diagnostic tests available in Menu 24.4 for your Prestige and the
connections.
Table 10-4 System Maintenance Menu Diagnostic
Field Description
Hang Up B1 Call This command hangs up the B1 channel. This is only applicable if the B1
channel is currently in use.
Hang Up B2 Call
This tool hangs up the B2 channel. This is only applicable if the B2 channel is
currently in use.
Reset ISDN This command re-initializes the ISDN link to the telephone company.
ISDN Connection
Test
You can test to see if your ISDN line is working properly by using this option.
This command triggers the Prestige to perform a loop-back test to check the
functionality of the ISDN line. If the test is not successful, note the error
message that you receive and consult your network administrator.
Manual Call
This provides a way for you to place a call to a remote node manually. This
tests the connectivity to that remote node. When you use this command, the
screen displays what is happening during the call setup and protocol
negotiation. Below is an example of a successful connection.
Internet Setup
Test
This test checks to see if your Internet access configuration has been done
correctly. When this option is chosen, the Prestige places a manual call to the
ISP remote node. If everything is working properly, you will receive an
appropriate response. Otherwise, note the error message and consult your
network administrator.
Ping Host This diagnostic test pings the host, which determines the functionality of the
TCP/IP protocol on both systems and the links in between.
Reboot System This option reboots the Prestige.
Command Mode
This option allows you to enter the command mode. This mode allows you to
diagnose and test your Prestige using a specified set of commands.
The following figure shows an example of a successful connection after selecting option Manual
Call in Menu 24.4.