Filter
Top Products
Prestige 100 and 100IH ISDN Router and Router/Hub
4-4 Remote Node Configuration
Incoming: Callback
This field is applicable only if Call Direction is Both.
Otherwise, a N/A appears in the field.
This field determines whether or not your Prestige will call
back after receiving a call from this remote node.
If this option is enabled, your Prestige will disconnect the
initial call from this node and call it back at the Outgoing
Primary Phone Number (see below).
Enable
Disable
Outgoing:
My Login
Name
This is a required field [?] if Call Direction is either Both
or Outgoing. Enter the login name for your Prestige when
it calls this remote node.
Outgoing: My
Password
This is a required field [?] if Call Direction is either Both
or Outgoing. Enter the password for your Prestige when
it calls this remote node.
This field sets the authentication protocol used for
outgoing calls.
Options for this field are:
l CHAP/PAP - Your Prestige will accept either CHAP
or PAP when requested by this remote node.
CHAP/PAP
l CHAP - accept CHAP only. CHAP
Outgoing: Authen
l PAP - accept PAP only. PAP
Outgoing:
Pri(mary)
Sec(ondar
y) Phone
Numbers
Your Prestige always calls this remote node using the
Primary Phone number first for a dial-up line.
If the Primary Phone number is busy or does not answer,
your Prestige will dial the Secondary Phone number if
available.
Some areas require dialing the pound sign # before the
phone number for local calls. A # symbol may be included
at the beginning of the phone numbers as required.
Edit PPP Options
To edit the PPP options for this remote node, move the
cursor to this field, use the space bar to select Yes and
press [Enter]. This will bring you to Menu 11.2 - Remote
Node PPP Options. For more information on configuring
PPP options, see the section Editing PPP Options.
Press space
bar to toggle
Yes then
press [Enter]
Rem IP Addr
This is a required field [?] if Route is set to IP. Enter the
IP address of the remote gateway.