ZyXEL Communications 100IH Router User Manual


 
Prestige 100 and 100IH ISDN Router and Router/Hub
6-6 Dial-In Server Configuration
PAP Password This field is applicable only if the Mutual Authen. Field is
set to Yes. Enter in the PAP password to be used to
respond to the far end’s authentication request. This field
does not apply to CHAP authentication.
Multiple Link Options:
Max Trans Rate Enter the maximum data transfer rate between your
Prestige and the remote dial-in user. 64 - At most, one B
channel is used. 128 - A maximum of two channels can
be used. When the Prestige calls back to the remote
dial-in user, the maximum data transfer rate is always 64.
64/128
Callback Budget
Management:
Allocated Budget (min)
This field sets the budget callback time for all the remote
dial-in users. The default for this field is 0 for no budget
control.
Default = 0
Period (hr) This field sets the time interval to reset the above
callback budget control.
IP Address Supplied By:
Dial-in User If set to Yes, the Prestige will allow a remote host to
specify its own IP address.
If set to No, the remote host must use the IP address
assigned by your Prestige from the IP pool, configured
below. This is to prevent the remote host from using an
invalid IP address and potentially disrupting the whole
network.
(Default = Yes)
Yes/No
IP Pool This field tells your Prestige to provide the remote host
with an IP address from the pool. This field is required if
Dial-In IP Address Supplied By: Dial-in User is set to
No. You can configure this field even if Dial-in User is set
to Yes, in which case your Prestige will accept the IP
address if the remote peer specifies one; otherwise, an
IP address is assigned from the pool.
Yes/No
(Default = No)
IP Pool: IP Start Addr This field is applicable only if you selected Yes in the
Dial-In IP Address Supplied By: IP Pool field.
The IP pool contains contiguous IP addresses and this
field specifies the first one in the pool.