A SERVICE OF

logo

Open as PDF
next previous
4 - 116
4 Setup
MITSUBISHI CNC
【#3104】 sp_t 4 Acceleration/deceleration time constant with S command (Gear: 11)
Set the acceleration/deceleration time constant with S command (speed operation mode) when gear
11 is selected. Set the linear acceleration/deceleration time up to limit rotation speed (slimit4). Set
the short time constant that the motor torque at acceleration is always saturated, however, when an
abnormal noise or V-belt slip occurs, increase the time constant.
---Setting range---
0 to 30000 (ms)
【#3105】 sut Speed reach range
Set the speed deviation rate with respect to the commanded speed, at which the speed reach signal
will be output.
It will be 15% when set to "0".
If the speed deviation is smaller than 45r/min, it will be set as 45r/min.
---Setting range---
0 to 100 (%)