Appendix 2 - 7
MDS-D2/DH2 Series Instruction Manual
Appendix 2.1 CMV1-xPxxS-xx Plug Connector
<When connecting>
[1] Set the mark of each other’s connectors.
[2] Each other’s key (concavity and convexity) are
fit in. Push it straight, take care not to tilt.
* To remove, rotate the coupling and
pull out to straight.
<When using a conduit>
[1] Tighten the nipple of conduit connector on the plug connector (CMV1).
[2] Set the conduit on the nipple of conduit connector.
[3] Fix the conduit to the plug connector (CMV1). If the conduit is used in a moving part, fix the conduit with a
saddle, etc. so that no load is applied to the plug connector (CMV1) and to the conduit connector.
If the conduit is fixed with a saddle, etc., make sure that no load is applied to the fixing area.
Set the protective cover (rubber etc.,) on the conduit to avoid cable damage.
Recommended conduit
Type: VF Type: SR Type: FBN Type: EM Type: VFS Type: SRK etc. (Note)
Recommended connector
Type:RCM (Note)
(Note) Manufactured by NIPPON FLEX CO.,LTD.
Contact: NIPPON FLEX CO.,LTD. http://www.nipolex.co.jp/
Receptacle connector key
(Convexity)
Plug connector key
(Concavity)
Push it straight
Push it straight
(1)
Rotate the coupling
(2)
Pull out to
straight
Coupling
Coupling
(1)
Rotate the coupling
(2)
Pull out to
straight
[1] [2] [3] [1] [2] [3]
Plug connector
Plug connector
Conduit
Conduit
Cable
Saddle
Protective cover
(rubber etc.)
Conduit
connector
(nipple)
Protective cover
(rubber etc.)
Cable
Saddle
Conduit
connector
(nipple)
