Configuring and Maintaining Your Server 99
Installing Modules
You can install a module to the Plesk server in two ways: from the control panel
(recommended), and from the command line.
To install modules from the control panel:
1 Login as administrator to the control panel.
2 Select the Modules shortcut in the navigation pane
3 Click Manage Modules.
4 Click Add new module.
5 Select a module package file, and click OK.
To install modules from the command line:
1 Login as root to the server, where Plesk is installed.
2 Run the command
/plesk_installation_directory/admin/bin/modulemng --
install --file=<module_filename>, where
'plesk_installation_directory' is the directory you installed Plesk to.
Example:
/usr/local/psa/admin/bin/modulemng --install --file=cs-gs-1.0.0-
rh9.build72041021.16.i586.rpm
Note: All modules that come with Plesk are located in the directory /opt/modules in Plesk
distribution.
Configuring and Managing Modules
Before you begin to use the module, you should configure it. Configuration steps vary
depending on each module. Once you install a module on the server using the control panel,
you are taken to the module‘s configuration screen. If you installed the module from the
command line, you need to configure it via Plesk.
To access the module configuration screen:
Select the Modules shortcut in the navigation pane, and then click the button labeled with
module‘s name.
Or
Select the Modules shortcut in the navigation pane, and then click Manage Modules. In the
list of modules, click the module‘s name presented as link.
