Filter
Top Products
-12-
??19.8E
&& &%$&'$%+%&
To prevent personal injury, always
dis con nect plug from power source
before attaching or removing the Smart Guard
System.
"!%&! &$(
1. Remove table insert using finger hole.
2. Raise the blade as high as it will go and set it per-
pendicular to table (0° on bevel scale) (Fig. 5).
3. Rotate the riving knife release lever clockwise,
so that it points upward (Fig. 5).
4. Pull riving knife towards release lever to disen-
gage it from the pins .
5. Slide the riving knife up to its highest position,
so that it is directly over the center of the blade
(Fig. 6).
6. Align holes in riving knife with pins and lock the
release lever by rotating it counterclockwise.
Push/pull riving knife to verify that it is locked in
place (Fig. 6).
7. Replace table insert (Fig. 7).
&& &'$%%+
8. With one hand, hold the front of the barrier
guard assembly by the metal “fork”. With the
other hand, hold the guard release lever up
(Fig. 7).
9. Lower the rear of guard assembly and slip the
cross bar into the rear notch on top of the
riving knife (Fig. 7).
!
WARNING
FIG. 5
FIG. 6
1
2
1
3
2
FIG. 7
4
5
7
6
2
BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 12