Filter
Top Products
-16-
!' & &&%)
If table saw is to be used in a permanent location, it
should be fastened securely to a firm supporting sur-
face such as a stand or workbench, using the four
mounting holes (Fig. 16).
1. If mounting to a workbench, the base should be
bolted securely using 1/4" hex bolts (not included)
through mounting holes .
5:@ If workbench is 3/4” thick, bolts will have to
be at least 3-1/2” long - if workbench is 1-1/2”
thick, bolts should be at least 4-1/2” long.
2. Locate and mark where the saw is to be mounted,
relative to holes in the base of the tool.
3. Drill four (4) 3/8" diameter holes through work-
bench.
4. Place table saw on workbench aligning holes in
base with holes drilled in workbench.
5. Insert four (4) 1/4" dia. bolts through holes in base
and supporting surface; then secure with (4) 1/4”
flat washers and (4) 1/4" hex nuts.
1
2
3
3
2
4
1
5
FIG. 14
6
FIG. 16
FIG. 15
RIP FENCE
STORAGE
1/4” HEX BOLT,
WASHER &
HEX NUT
X4
BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 16