Filter
Top Products
-36-
&>;A.81?4;;@5:3
Turn switch “OFF” and always remove plug from the power source before trouble shooting.
TROUBLE: SAW WILL NOT START
PROBLEM 1. Power cord is not plugged in.
2. Fuse or circuit breaker tripped.
3. Cord damaged.
4. Burned out switch.
REMEDY 1. Plug saw in.
2. Replace fuse or reset tripped circuit breaker.
3. Have cord replaced by an Authorized Bosch Service Center or Service Station.
4. Have switch replaced by an Authorized Bosch Service Center or Service Station.
TROUBLE: BLADE DOES NOT COME UP TO SPEED
PROBLEM 1. Extension cord too light or too long.
2. Low house voltage.
REMEDY 1. Replace with adequate cord.
2. Contact your electric company.
TROUBLE: EXCESSIVE VIBRATION
PROBLEM 1. Failure to tighten tilt lock handle.
2. Blade out of balance.
3. Saw not mounted securely to stand or workbench.
4. Arbor Nut not tight.
REMEDY 1. See “Getting To Know Your Table Saw” section, (Page 9- 10).
2. Discard Blade and use different blade.
3. Tighten all mounting hardware, See “Mounting the Table Saw” section, (Page 16).
4. See “Assembly” section, “Changing The Blade” (Page 14-15).
TROUBLE: CUT BINDS, BURNS, STALLS MOTOR WHEN RIPPING
PROBLEM 1. Dull blade with improper tooth set.
2. Warped board.
3. Rip fence not parallel to blade.
4. Spreader out of alignment..
REMEDY 1. Sharpen or replace blade.
2. Make sure concave or hollow side is facing “DOWN” feed slowly.
3. See “Operating Adjustments” section “Aligning Rip Fence” (Page 19).
4. See “Assembly” section, “Attaching Blade Guard” (Page 12 - 13).
TROUBLE: CUT NOT TRUE AT 90° OR 45° POSITIONS
PROBLEM 1. Alignment screws not adjusted properly.
REMEDY 1. See “Operating Adjustments” section, “Adjusting
Blade Parallel to Miter Gauge Slots” (Page 18).
TROUBLE: TILT LOCK HANDLE ELEVATION WHEEL HARD TO MOVE
PROBLEM 1. Blade tilt lock handle not loosened when making tilt adjustment.
2. Saw dust on depth screw threads.
REMEDY 1. See “Getting To Know Your Table Saw” section, “Blade Tilt Lock Knob” (9-10).
2. See “Maintaining Your Table Saw” section, “Lubrication” (Page 35).
!
WARNING
BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 36