Filter
Top Products
-24-
'% &$" "! &$
) &% !&
*&
The rip fence pointer shows the distance from the
blade to rip fence through a convenient viewing.
Align rip fence pointer with lower portion of scale
. The lower scale can be used for widths up to 10
inches (Fig. 36).
'% &&"! &$
) &%*&
The upper portion of scale is used for rip cut 10 to
18 inches. Align table pointer with upper portion of
scale (Fig. 36).
!& The maximum cutting capacity to the right of
the blade when the extension table is closed is 10”,
as noted on the scale. To achieve this capacity, a
portion of the fence glide pads, located underneath
the locking lever, will hang off the rail. The maximum
cutting capacity to the right of the blade when the
extension table is fully extended is 18”. To achieve
this capacity, a portion of the fence glide pads, lo-
cated underneath the locking lever, will hang off the
rail. In either case the rip fence pointer should never
be positioned beyond 10” on the lower scale for
maximum cutting capacity (Fig. 37).
FIG. 36
4
5
6
7
11
(! &$!
Loosen blade bevel lock handle counterclockwise
(Fig. 35), slide the elevation wheel until pointer
is at desired angle and tighten blade tilt lock handle
clockwise.
*& &*& %!
To extend the table, raise the table extension lock
handle (Fig. 35) and slide table extension to de-
sired width (Fig 35a). To secure table setting, lower
the lock handle .
FIG. 35
4
213
FIG. 35a
5
EDGE OF TABLE
BODY OF FENCE
FIG. 37
BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 24