Filter
Top Products
Launching the Security Configuration Window 6-3
Ring Security Configuration
The Security Configuration Ring Selection window, Figure 6-1, will appear.
Figure 6-1. The Security Configuration Ring Selection Window
The Ring Selection window displays each manageable network supported by the
monitored device, and lets you access a Security Config window to configure
security for the selected ring. Networks are identified by the following two fields:
No.
The index number assigned to each ring network.
Ring Name
This field displays the ring name assigned to each network.
To set up security for the ring network being managed by the TRMMIM, click
mouse button 1 to select the desired ring, then click mouse button 1 on
. The Security Config window (Figure 6-2) will appear.
NOTES
The spmarun script invoked first in the above command temporarily sets the environment
variables SPMA needs to operate; be sure to use this command any time you launch an
application from the command line. This script is automatically invoked when you launch
an application from the icon menu or from within the Hub View.
If you wish to change any Security settings, be sure to use a community name with at
least Read/Write access. If you only wish to view current settings, a community name
with Read access will be sufficient.
If there is a hostname mapped to your TRMMIM’s IP address, you can use <hostname>
in place of <IP address> to launch this application. Please note, however, that the
hostname is not the same as the device name which can be assigned via Local
Management and/or SPMA; you cannot use the device name in place of the IP address.