Filter
Top Products
2-14
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-04
Chapter 2 Route Switch Processors and Supervisor Engines
Supervisor Engine 2
Supervisor Engine 2
This section describes the Supervisor Engine 2 (see Figure 2-6), which has slightly different controls and
features than the Supervisor Engine 720 and Supervisor Engine 32. Table 2-4 describes the controls and
features on the front panel and Table 2-5 describes the LEDs.
Note In Cisco IOS Release 12.2SR and later releases, the Supervisor Engine 2 is no longer supported on
Cisco 7600 series routers.
Figure 2-6 Supervisor Engine 2 Front Panel
ACTIVE
Green The supervisor engine or RSP is operational and active.
Orange The supervisor engine or RSP is powering up or is in standby mode.
PWR MGMT
1
Green Sufficient power is available for all modules installed in the router.
Orange The supervisor engine or RSP is powering up or has minor hardware
problems.
Red Major hardware problem.
DISK
Green The disk is active. Do not remove the disk while the light is on or the file
may be corrupted.
LINK
Green The port is operational.
Orange The port is disabled.
Flashing
orange
The port is bad.
Off The supervisor engine or RSP is powering up or the port is enabled and
there is no link.
1. The SYSTEM and PWR MGMT LEDs on a redundant supervisor engine or RSP are synchronized to the active module.
Table 2-3 RSP720, Sup720, and Sup32 LEDs (continued)
LED Color Description
44312
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1 PORT 2
Switch Load
100%
1%
LINK
LINK
PCMCIA LED
LINK LEDs
Status
LEDs
RESET button
CONSOLE port
CONSOLE PORT
MODE switch
PCMCIA slot
1000BASE-X GBIC
Uplink Ports
Switch load
display