Filter
Top Products
3-13
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-04
Chapter 3 Installing and Configuring Route Switch Processors and Supervisor Engines
Using Flash Memory Cards
Table 3-3 lists the Cisco product numbers of memory cards supported on Cisco 7600 supervisor engines
and route switch processors.
Installing a Flash Memory Card
To install a flash memory card, follow these steps:
Step 1 Hold the memory card with the connector end of the card toward the slot. The connector end of the card is
opposite the end with the write-protection switch (if there is one), which is shown in
Figure 3-5.
Step 2 Slide the card into the slot until the device completely seats in the connector at the back of the slot and
the ejector button pops out toward you.
Caution Do not attempt to force the memory card fully into the slot or you could damage the connector pins.
When correctly inserted, a portion of the device remains outside the slot.
Step 3 Format the memory card the first time that it is installed in the system.
Note Be sure to format the memory card with the type of supervisor engine or route switch processor that the
card is being used with. A memory card formatted for one type of supervisor engine or route switch
processor may not work with another type.
Tab le 3-3 CompactFlash Memory Cards
Product Number Description
RSP720 and RSP720-10GE Flash Memory Cards
MEM-RSP720-CF256M Cisco CompactFlash Memory Card, 256 MB
MEM-RSP720-CF512M Cisco CompactFlash Memory Card, 512 MB
MEM-RSP720-CF1G Cisco CompactFlash Memory Card, 1 GB
Sup720 and Sup32 Flash Memory Cards
MEM-C6K-CPTFL64M Cisco CompactFlash Memory Card, 64 MB
MEM-C6K-CPTFL128M Cisco CompactFlash Memory Card, 128 MB
MEM-C6K-CPTFL256M Cisco CompactFlash Memory Card, 256 MB
MEM-C6K-CPTFL512M Cisco CompactFlash Memory Card, 512 MB
Sup2 Flash Memory Cards
MEM-C6K-ATA-1-64M Cisco ATA Type 1 Flash Memory Card, 64 MB