Filter
Top Products
3-53
Cisco 3600 Series Routers Hardware Installation Guide
OL-2056-05
Chapter 3 Installing the Router
Configuring the Router
If SDM is installed on your router, Cisco recommends using SDM to perform the initial
configuration. For configuration procedures using SDM, refer to the quick start guide that shipped
with your router.
You can also access the Cisco 3600 series routers quick start guides online at:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3600/36xx_qsg/index.htm
• If you see the following messages, the router has booted and is ready for initial configuration using
the setup command facility or the command line interface (CLI).
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
To learn how to use the setup command facility to configure the router, see the “Initial Configuration
Using the Setup Command Facility” section on page 3-54. To learn how to use the CLI to configure
the router, see the “Initial Configuration Using the CLI (Manual Configuration)” section on
page 3-57.
Note If the rommon 1> prompt appears, your system has booted in ROM monitor mode. For information on the
ROM monitor, see the router rebooting and ROM monitor information in the Cisco IOS Configuration
Fundamentals Configuration Guide for your Cisco IOS software release.
Configuring the Router
You can configure your router by using one of the following tools:
• Security Device Manager. If your router was purchased with a VPN bundle, Security Device
Manager is installed on the router. See the “Initial Configuration Using SDM” section on page 3-53
• Setup command facility. you can use the setup command facility to prompt you for basic router
information. After the configuration file has been created, you can use the CLI or use Security
Device Manager to perform additional configuration. See the “Initial Configuration Using the Setup
Command Facility” section on page 3-54.
• Command-line interface (CLI). If you prefer to use the Cisco IOS CLI, see the “Initial Configuration
Using the CLI (Manual Configuration)” section on page 3-57 for instructions on how to use the CLI.
Initial Configuration Using SDM
If Security Device Manager has been installed on your router, the following messages appear at the end
of the startup sequence:
yourname con0 is now available
Press RETURN to get started.
For configuration procedures using SDM, refer to the quick start guide that shipped with your router.
You can also access the Cisco 3600 series routers quick start guides online at:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3600/36xx_qsg/index.htm