Filter
Top Products
11
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
Starting the Cisco WAE Network Module and Displaying Status
Accessing the ACNS Software on the Network Module
You can access the ACNS software that runs on the network module by first accessing one of the
following:
• The router IOS command-line interface (CLI) to open a console session to the network module
• The ACNS Content Distribution Manager graphical user interface (GUI)
For details about configuring and maintaining your ACNS network, see the following documents:
• Cisco Application and Content Networking System Software Configuration Guide for Centrally
Managed Deployments
• Cisco Application and Content Networking System Software Configuration Guide for Locally
Managed Deployments
• Cisco Application and Content Networking System Software Command Reference
When using the ACNS Content Distribution Manager GUI for an NME-WAE device, the internal
interface to the router is designated as slot 1, port 0 and the external network interface is designated as
slot 2, port 0, regardless of the physical slot in which the NME-WAE is installed.
Shutting Down and Starting Up Cisco WAE Network Modules
To shut down or start up the network module or the ACNS software that runs on the module, use a
command from the common router and network module commands listed in Table 2.
Be aware of the following command functions:
• Shutdown commands can potentially disrupt service. The command output will display a
confirmation prompt before shutdown occurs. Confirm by pressing Enter or cancel by typing n and
pressing Enter. To prevent the prompt from displaying, use the no-confirm keyword.
• Some commands shut the module or application down and then immediately restart it.
Table 2 Common Shutdown and Startup Commands
Configuration Mode Command Purpose
Router#
service-module
integrated-service-engine
slot/0 reload
Shuts down the network module operating
system gracefully and then restarts it from
the bootloader.
Router#
service-module
integrated-service-engine
slot/0 reset
Resets the hardware on a module. Use this
command only to recover from shutdown or
a failed state.
Caution Using this command does not
provide an orderly software
shutdown and may impact file
operations that are in progress.
Router#
service-module
integrated-service-engine
slot/0 session
Accesses the specified service engine and
begins a network module configuration
session.