Filter
Top Products
25
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
service-module integrated-service-engine statistics
service-module integrated-service-engine statistics
To display reset and reload information for an integrated-service-engine (ISE) network module and its
IOS software, use the service-module integrated-service-engine statistics command in EXEC mode.
service-module integrated-service-engine slot/unit statistics
Syntax Description
Defaults none
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines The statistics displayed by this command represent control communication events between the network
module and the router. For ACNS-specific statistics, access the ACNS CLI and use the show statistics
commands documented in the Cisco Application and Content Networking System Software Command
Reference.
Examples The following example displays information for an ISE network module that is installed in slot 2 of an
access router:
Router# service-module integrated-service-engine 2/0 statistics
Module Reset Statistics:
CLI reset count = 1
CLI reload count = 0
Registration request timeout reset count = 0
Error recovery timeout reset count = 0
Module registration count = 2
The last IOS initiated event was a cli reset at *13:34:33.847 UTC Sun Dec 18 2005
slot Slot number of the network module in the router chassis.
/unit Number of the daughter card on the network module. For ISE network
modules, always use 0. The slash mark (/) is required between the slot
argument and the unit argument.
Release Modification
12.4(9)T This command was introduced for ISE network modules.